What Does p80 glock 17 frame Mean?
What Does p80 glock 17 frame Mean?
Blog Article
If you only can’t obtain the pins to endure (Primarily around the rear polymer one particular)…and also you search by means of to see obstructions. You may re-drill carefully.
Back again to login Account by now exists We noticed that you have previously logged in with your Account which is associated with the same electronic mail tackle () - we could url equally of the accounts with each other.
That is what I've observed on my SS80 (Glock forty three). My gun completely locked up and it appeared to me which the locking block wasn't absolutely level While using the frame. Your feelings can be appreciated. Many thanks
I like building versions far too. Ghost gun can make it seem Unique to a lot of who You should not need such a point. Absolutely everyone hopes to be a rebel ssshhhhhhhhhh... I've a gun no person knows its a magic formula
At time of this producing, a citizen of the United States can Make his or her have firearm for private use with out a license underneath federal regulation. This firearm isn't going to require to have a serial selection, be registered or be transferred through a federally licensed firearms vendor underneath federal regulation.
It ended up staying a nightmare! It is actually very little like another builds from p80. Practically all the other models are effortless to make and you don't operate into too many difficulties.
GLOCK Mounting Rail trim The frame has an built-in rail in front of the bring about guard. This permits mounting of equipment which include tactical lights and lasers. Front serrations To offer a distinct appear and yet another tactile surface to carry out a quick push check just before and right after firing.
On my next Create I DID utilize a drill press to drill the holes. The plastic jig just is just not deep ample to hold a bit in fantastic, perpendicular alignment for "hand drilling" - so that acquired tossed soon after my 1st frame ended up with holes on either aspect at any time so a little bit off. But when using the drill push, I did not clamp the jig, I taped it quite securely, using care to contain here the very same thickness of tape on all ends, then held the jig around the table by hand as I introduced the bit. This allowed the jig to "Centre" given that the bit went in properly perpendicular! The resulting pin holes have been cleanse, aspect-to-aspect! Then I inserted the rear rail piece and squeezed it down.
Locate the modest coiled spring and thoroughly “drop” it into the opening close to the center within your P80 One Stack or G43 frame.
Only present this user There is a extensive thread concerning the changes. I wound up filing off an exceedingly smaller volume of material from The underside in the -02 followers to get them to operate. Other people have clipped the spring to get them to work.
I agree that for the JIG not to contain the reference holes placed properly is just negligent of the producer not to take care of it and about the retailer for not insisting they are doing, when they know.
You have a picture of it included in your components shot but no mention of it or how to setup it. On you tube they recommended just a daily Bic pen to drive it in, which labored flawlessly. Thanks for that posting, other than that It is magnificent!!
The sanding belt I use is definitely the mid grade and is particularly super easy to view in which the rails should be sanded down (the curved are on the rear rail.. I did not sand much but it had been definitely much easier than a curved file or sand paper.
Whatever element isn't working…check out all of it with inventory OEM elements. Occasionally aftermarket slides and triggers have too restricted tolerances to work in a very P80. To date the Brownells and Gray Ghost (somewhat limited) have worked in my builds. I’ve listened to ZEV slides could be too restricted.